Basic Fax Operation38
Sending a Fax Using the Original Glass
1 Press the Fax key to enter Fax mode.
2 Remove all documents from the ADF.
" If you are using the original glass to scan, do not load any documents
into the ADF.
3 Lift to open the ADF cover.
4 Place the original document face down on the original glass and align the
document on the scales above and to the left of the original glass.
5 Gently close the ADF cover.
" Closing it too quickly may cause the document to move on the original
glass.
6 Adjust the document image quality.
" For details on adjusting the document image quality, refer to “Adjust-
ing the Image Quality” on page 40.
7 Specify the fax number of the recipient in one of the following ways:
– Direct dialing
– Using the favorite list
– Using the Speed Dial function
– Using the Group Dial function
– Using the Phone Book functions
– Using the Redial/Pause key
" For details on specifying the recipient, refer to “Specifying a Recipient”
on page 41. For details on using the Redial/Pause key, refer to “Using
the Redial Function” on page 44.
" A transmission can also be sent to multiple recipients with the Broad-
cast function. For details on sending a broadcast transmission, refer to
“Sending a Fax to Multiple Recipients (Broadcast Transmission)” on
page 45.
8 Press the Start key.
A screen appears, requesting confirmation of the scanning area.
9 To scan the displayed scanning area, press the Select key. The document
is scanned.
" To change the displayed scanning area, press the
+
or
,
key, select
the desired scanning area. Press the Select key again to start scan-
ning.
Comments to this Manuals