Specifying Settings From the Control Panel
3
C252 3-135
Specifying Settings From the Control Panel Chapter 3
Port No.
Specify the port number that other systems access using OpenAPI (initial
port number: 50001, initial port number (SSL): 50003).
1 In the Administrator Setting screen, touch [System Connection]. (Refer
to page 3-8 for more details.)
2 In the System Connection screen, touch [1 OpenAPI Setting].
3 In the OpenAPI Setting screen, touch [Port No.].
The OpenAPI Port Setting screen appears.
4 Press the [C] (clear) key to erase the value, and then use the keypad to
type in the value (between 1 and 65535).
– If a value outside of the allowable range is specified, the message
“Input Error” appears. Type in a value within the allowable range.
5 Touch [OK].
– To cancel changes to the setting, touch [Cancel].
The port number that other systems access using OpenAPI is set.
2
Note
If the port number for SSL communication is specified, the certificate
must be pre-installed from PageScope Web Connection. For details, re-
fer to “SSL/TLS” on page 4-100.
Comments to this Manuals