Konica-minolta NC-503 User Manual Page 86

  • Download
  • Add to my manuals
  • Print
  • Page
    / 244
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 85
Network settings
4
NC-503 4-35
6 Use the keypad to type in the NTP server address, and then press the
[OK] key.
If an NTP server was specified:
The date and time that data is sent with the Scan to E-Mail or Scan
to FTP operation are automatically added to the data at the same
time that the transmission date and time are recorded in the trans-
mission log.
If an NTP server was not specified:
Only a transmission number is added to data sent with the Scan to
E-Mail or Scan to FTP operation; the transmission date and time are
not added to the data. In addition, the date and time are not record-
ed in the transmission log.
For the NTP server address, consult with the network administrator.
The message “ACCEPTED” appears, and then the “USER SETTING”
menu appears again.
7 Press the [Reset] key.
The time is acquired from the NTP server, and then the time on the ma-
chine is set.
Specifying the time zone
1 Press the [Utility] key in the control panel.
Page view 85
1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 243 244

Comments to this Manuals

No comments