Konica-minolta bizhub 42 User Manual download pdf (Page 72)

bizhub 42/36 7-3

7.1 Paper

7.1.2 Loading paper

This section describes how to load paper into each tray.

If printing stops due to the tray being empty, load paper into the tray. Printing restarts automatically.

For the types of paper to be used, refer to page 10-2.

Loading paper in Tray 2, Tray 3, Tray 4, or Tray 5

The procedure for loading paper is common between Tray 2, Tray 3, Tray 4, and Tray 5.

The following procedure describes how to load paper into Tray 2.

0 Tray 4 and Tray 5 are optional.

0 The size of loaded paper is automatically detected.

1 Pull out Tray 2.

% 1. Film

NOTICE

Be careful not to touch the Film.

2 Slide the Lateral Guide to fit the size of paper being loaded.

% If the Lateral Guide are not positioned correctly for the loaded

paper, the paper size will not be correctly detected.

3 Load the paper into the tray so that the side of the paper to be

printed on (the side facing up when the package was unwrapped)

faces up.

% Do not load so many sheets of paper that the top of the stack

is higher than the , mark.

% If paper is curled, flatten it before loading it.

% If special paper is loaded, the paper type must be specified.

% Load letterhead paper so that the side to be printed on faces

up.

4 Close Tray 2.

d Reference

To configure paper settings:

Press [Copy] or the Copy key ö [Paper].

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 108 109

No comments

Konica-minolta bizhub 42 User Manual Page 72