Konica-minolta eCopy User Manual download pdf (Page 12)

8 | Installing and configuring the connector

Configuring the connector

This section explains all the connector configuration options and the procedure for setting up an

Express connector profile for more streamlined use (see page 12).

To configure a connector profile:

1 In the console tree, select Livelink > Properties.

2 Select the Display tab and configure the Image and Label options for the connector

button (see “Configuring the Display settings” in the eCopy ShareScan OP Installation and

Setup Guide or the eCopy ShareScan OP Configuration Help). The button that the user sees at

the eCopy-enabled device displays the information that you specify on this tab. To avoid

confusion, if you create more than one connector profile, you should give each profile a

unique button label.

3 Select the Configure tab and define the scanning destination (see Table 1).

4 Click Save, select or specify the profile name, then click Save.

The system saves your settings as part of the connector profile, or creates a new profile.

See “Creating and saving connector profiles” in the eCopy ShareScan OP Installation and Setup

Guide or the eCopy Connector for Livelink ECM Help.

5 In the console tree, select Livelink > Services.

The Services pane appears.

6 Configure the connector services.

See “Configuring Connector Services” in the eCopy ShareScan OP Installation and Setup Guide

or the eCopy Connector for Livelink ECM Help.

7 Click Save, select the profile name, then click Save.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 25 26

No comments

Konica-minolta eCopy User Manual Page 12