Konica-minolta bizhub 181 User Manual download pdf (Page 15)

Installing the printer driver

2-2 GDI Printer Controller

Connecting to the network

In the following procedure, the machine is connected directly to the compu-

ter by using a network cable.

In order to connect the machine to a network, the optional network interface

card NC-503 or image controller IC-206 must be installed. For details on the

network interface card NC-503, refer to the User’s Guide for the network in-

terface card. For details on the image controller IC-206, refer to the User’s

Guide for the image controller.

When the machine is connected to a network, use the Add Printer Wizard to

install the printer driver. For the procedure on installing the printer driver

when this machine is connected to a network, refer to “Installing the printer

driver by using the Add Printer Wizard” on page 2-13.

Procedures for making connections and installing the driver

The printer driver can be installed by using Plug and Play or by using the Add

Printer Wizard.

The installation procedure differs depending on the method used to make

the connection. Use the installation method that corresponds with the con-

nection method.

Reminder

If the machine is to be connected to a USB port, install the driver by using

Plug and Play. If the machine is to be connected to a network, install the

driver by using the Add Printer Wizard.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 91 92

No comments

Konica-minolta bizhub 181 User Manual Page 15